Contribute
Register

probook 470 g2 won't boot after update

Status
Not open for further replies.
Joined
Dec 24, 2012
Messages
37
Motherboard
HP folio 1040 g2 (Clover V4813)
CPU
i5-5300u
Graphics
HD5500, FHD
Mobile Phone
  1. Android
Hallo,
i did something really mindless yesterday: i update from appstore from El Capitan 10.10 to ( i thought) 10.11.x
To bad after that my system do not boot properly: it reboot after only 3 line of clover loading stuffs. I can still boot the osx recovery mode partition, and the windows 10 installation, so clover works and i can access to terminal, disk utility, ecc ecc. My guess is that the update remove some mandatory kext, but from that point on i don't know how to precede, becouse my googling failed me =(
Any hints =)?
regards,
Francesco
 
Hallo,
i did something really mindless yesterday: i update from appstore from El Capitan 10.10 to ( i thought) 10.11.x
To bad after that my system do not boot properly: it reboot after only 3 line of clover loading stuffs. I can still boot the osx recovery mode partition, and the windows 10 installation, so clover works and i can access to terminal, disk utility, ecc ecc. My guess is that the update remove some mandatory kext, but from that point on i don't know how to precede, becouse my googling failed me =(
Any hints =)?
regards,
Francesco

Follow guide:

http://www.tonymacx86.com/threads/g...book-using-clover-uefi-hotpatch-10-11.189416/
 
So i think i'll be easiest to begin a whole new installation following that guide, instead of recover the "broken" one.
Thank you,
Francesco
 
So i think i'll be easiest to begin a whole new installation following that guide, instead of recover the "broken" one.
Thank you,
Francesco

It depends on how broken your setup is. If it is just your Clover setup that is wrong, you can read the guide to find information on how to correctly configure Clover for your hardware.
 
Status
Not open for further replies.
Back
Top