I removed the USB kext file, replaced the config.plist and try every single usb port, but it does not go any further. Still stuck at those lines.
Did you try the alternate DropTables as mentioned in post #1?
Try also config.plist/ACPI/SSDT/DropOem=true.
Also, you might look at the USB guide:
http://www.tonymacx86.com/el-capitan-laptop-support/173616-guide-10-11-usb-changes-solutions.html
Also... when reporting an issue, you must provide data...
Boot verbose, show photo. Post EFI/Clover folder as ZIP (omit 'themes' folder).
--
Are you booting UEFI or legacy?
Please provide complete details
in your profile/signature
(Profile/Settings link in upper right corner of this site)
Mobo: manufacturer/model + bootloader(Clover/Chameleon/Chimera)
CPU: detailed CPU model + motherboard chipset
Graphics: all graphics devices + laptop internal screen resolution
For example, typical Ivy laptop:
Mobo: HP ProBook 4540s (Clover)
CPU: i5-3320m/HM76
Graphics: HD4000, 1366x768
Use CPU-Z on Windows to find CPU (Core iX-xxx) and motherboard chipset (HMxx), and graphics capabilities. For a laptop, these details are important and affect critical installation procedures.
Note: When specifying your bootloader, if using Clover legacy, please be sure to specify "Clover legacy"). Specifying "Clover" will be assumed as "Clover UEFI"