Clover boot loader language is wrong

[Powercooler]

Hello :S

im in a bit of a pickle with my boot loader, because if i want to load it up, i need to type GraphicsEnabler=Yes or =no i dont know yet, but because my keyboard i scandinavian, when i dont have = at the same spot that the boot loader thinks its at.

So what do you guys think i should do?

do you know the key combination? (i know its ctrl + = but its the position of = im talking about)

Hope you can help
Rasmus

 

[neilhart]

Hello :S

im in a bit of a pickle with my boot loader, because if i want to load it up, i need to type GraphicsEnabler=Yes or =no i dont know yet, but because my keyboard i scandinavian, when i dont have = at the same spot that the boot loader thinks its at.

So what do you guys think i should do?

do you know the key combination? (i know its ctrl + = but its the position of = im talking about)

Hope you can help
Rasmus

With Clover you do not use GraphicsEnabler so this should not be a problem. As needed you would set the ATI, Nvidia or Intel argument to true in the config.plist.

Also when you reach the Clover device selection screen, press the arrow key to move to the "Options" menu where you can configure boot arguments to be used in the current boot (these are not saved).

Good modding,
neil

 

[Powercooler]

then i dont know why it worked after i set graphics enabler to no. it can be that i changed something wrong before?

I found out that i could hold ctrl + ´ to get an = (equal).

anyway now it works. i think.