Contribute
Register

BCM94352z Yosmeite no USB Bluetooth

Status
Not open for further replies.
Joined
Oct 23, 2011
Messages
3
Motherboard
Toshiba
CPU
intel i5
Graphics
intel HD
Mac
  1. iMac
Classic Mac
  1. 0
Mobile Phone
  1. Android
Hello I am running Yosemite via Clover and have replaced my intel ngff card with BCM94352z.

Wifi is working perfectly with BCM kext, the only problem i have is that the Bluetooth will not

show up as a USB device in System Information. If i boot the machine in Windows it show up

as Usb\vid_0920\pid_0223\24fd528de611

Usb\vid_0930&PID_0223

Bios \SB.PCI0.XHC.RHUB.HS08

BCM20702 and works fine. Why doesnt OSx see the USB device, i know others have this card

working with no issues

Thanks
 
Hello I am running Yosemite via Clover and have replaced my intel ngff card with BCM94352z.

Wifi is working perfectly with BCM kext, the only problem i have is that the Bluetooth will not

show up as a USB device in System Information. If i boot the machine in Windows it show up

as Usb\vid_0920\pid_0223\24fd528de611

Usb\vid_0930&PID_0223

Bios \SB.PCI0.XHC.RHUB.HS08

BCM20702 and works fine. Why doesnt OSx see the USB device, i know others have this card

working with no issues

Thanks


post your vendor id and product id from system profiler-->USB-->your bluetooth device
 
I can't there is no BCM device listed in the usb panel in system information its not detected

but it is detected in Windows

Thats the problem
 
I can't there is no BCM device listed in the usb panel in system information its not detected

but it is detected in Windows

Thats the problem
Sounds like you haven't installed usb3.0 drivers, install it, then reply with the result
 
I have the usb 3 kext installed system information shows USB 3.0 Hi-Speed Bus

Thanks James
 
Verify if you see the following information in USB devices:

BCM20702-USB.png

If so, you can enable your Bluetooth with the driver in the following topic:
http://www.tonymacx86.com/network/1...ware-into-broadcom-bluetooth-usb-devices.html

Download the driver and place it in your EFI/CLOVER/kexts/10.10.

Fully shutdown the laptop (turn it off) and restart Yosemite.
 
Status
Not open for further replies.
Back
Top