- Joined
- Oct 22, 2013
- Messages
- 197
- Motherboard
- hm77
- CPU
- 4790k
- Graphics
- hd4000
I'm attempting to migrate a hackintoshed Dell D620 from an ancient Chameleon setup to something a little more modern. The computer has GMA950 graphics, and a 32bit processor, so 10.6.8 is the end of the line. I installed both Clover r3196 and r3203; both had the same results.
I've tried using the 32bit non-uefi VBoxHFS.efi and HFSPlus.efi (obtained from Clover Configurator; tried using both at the same time, individually, and without either), and while the Clover log indicates the hfs drivers load, it never detects the drive. If I boot this Clover USB on my Acer (x64UEFI), it'll detect HFS+ partitions, leading me to believe this is a problem with the 32bit HFS drivers. The drive is formatted GPT by the OSX 10.6.0 installer. It only has one partition.
I installed Clover to a MBR/FAT32 formatted USB drive with these options:
System:
Dell D620
Intel Core Solo T1400 (1.86GHz)
ICH7 Chipset
Intel GMA950 1280x800
Attached is my EFI folder.
Anyone have any ideas?
I've tried using the 32bit non-uefi VBoxHFS.efi and HFSPlus.efi (obtained from Clover Configurator; tried using both at the same time, individually, and without either), and while the Clover log indicates the hfs drivers load, it never detects the drive. If I boot this Clover USB on my Acer (x64UEFI), it'll detect HFS+ partitions, leading me to believe this is a problem with the 32bit HFS drivers. The drive is formatted GPT by the OSX 10.6.0 installer. It only has one partition.
I installed Clover to a MBR/FAT32 formatted USB drive with these options:
System:
Dell D620
Intel Core Solo T1400 (1.86GHz)
ICH7 Chipset
Intel GMA950 1280x800
Attached is my EFI folder.
Anyone have any ideas?