Contribute
Register

Crash when trying to install El Capitan

Status
Not open for further replies.
The XHD and HPET modes may no longer show up in the menus since you upgraded to the UEFI bios, so ignore these.

With regard to the RAM, if you use the 2x8GB for dual channel, do you see 16GB?

What's the error message on the screen now?
 
Build 2
GA-Z97X-GAMING 7 |  i5 4690K |  GeForce GTX 650 Ti
Build 3
GA-Z77-DS3H |  i5 3570 |  GeForce GTX 650 Ti
Build 4
GA-Z68X-UD3H-B3 |  i5 3570 |  Radeon HD 5770
Build 1
GA-Z270XP-SLI |  i5 7600K |  Radeon Other
ghorwith said:
The XHD and HPET modes may no longer show up in the menus since you upgraded to the UEFI bios, so ignore these.

With regard to the RAM, if you use the 2x8GB for dual channel, do you see 16GB?

What's the error message on the screen now?
Click to expand...

- If I use 2x8GB I only see 8GB
- Here is the new error message :

photo 31:08.JPG
 
ghorwith said:
Turn off EIST in bios (cpu overclocking), and add nullcpumanagement in the EFI 10.11 and Other folders
Click to expand...
Ok I disabled EIST and I just found the nullcpumanagement
 
Last edited:
Ghorwith you're the best !!!!!!! It works !!
Know I've to make some adjustments but I think the most difficult has been done.

Thank you so much! :D
 
Ghorwith,

Excellent support, dude!. :thumbup: Good fix.
 
Glad to hear this. I know it's been a struggle, but look at it as a learning experience. Once you've got 10.11 installed and run Multibeast to install Clover on the hd or ssd, you'll want to modify the config.plist you create in the EFI partition on the hd. You should be able to re-enable all of the cpus, and use EIST again, as well as make several other tweaks. Good luck.
 
Build 2
GA-Z97X-GAMING 7 |  i5 4690K |  GeForce GTX 650 Ti
Build 3
GA-Z77-DS3H |  i5 3570 |  GeForce GTX 650 Ti
Build 4
GA-Z68X-UD3H-B3 |  i5 3570 |  Radeon HD 5770
Build 1
GA-Z270XP-SLI |  i5 7600K |  Radeon Other
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top