Kernel panic with 10.11.4 on Skylake GA-H110M-S2H + HD530

Hi everyone,

For a while now I've been trying to install 10.11.4 on my GA-H110M-S2H and i5-6400 but without success. I only use the internal Intel HD 530 graphics.

With a default Clover USB stick created with UniBeast 6.1.1 and without any changes whatsoever I get the following kernel panic. The only boot flags are -v and dart=0.



I am able to get to the installer when I boot with -x (safe mode) but once I've installed Mac OS X I don't know how I should alter the system so that I can boot normally after that. Safe mode doesn't let me install the Clover bootloader onto the EFI partition.

Could someone help me with this? Any tips would be greatly appreciated.

Do you have a standard set of kexts in your Clover dir on your UBS install stick? And what customizations did you make when you used Multibeast to install Clover on your hard drive?

Please run -v singleuser, and take a photo of the last number of lines of output and post up here.

Also try nv_disable=1, along with the [FONT=arial, sans-serif]above -v singleuser, taking a photo.[/FONT]

Do you have a standard set of kexts in your Clover dir on your UBS install stick?

Click to expand...

Yes, I (only) have the kexts that UniBeast placed: AppleIntelE1000e, AtherosE2200Ethernet, FakeSMC and RealtekRTL8111.

And what customizations did you make when you used Multibeast to install Clover on your hard drive?

Click to expand...

I've tried a lot of settings for MultiBeast but nothing worked because the hard disk's EFI partition wouldn't mount because OS X was running in Safe Mode. This is what I try:


And this is what I get:

Please run -v singleuser, and take a photo of the last number of lines of output and post up here.

Click to expand...

Also try nv_disable=1, along with the above -v singleuser, taking a photo.

Click to expand...

10.11.0-10.11.3 Skylake Starter Guide

Click to expand...

Thanks but I thought a lot has changed with 10.11.4. The guide states that it's not yet updated to reflect these changes.

Hi have you had any luck as im about to buy novatech bundle that comes with a i3 6100 and this mob and i was going to use a gt/gtx gpu and i want to know if this would work iv got a clover stick i got off eBay that iv used in the past to install mac osx el capetan on other hard ware like a i3 lga 1155 CPU just wondering if you got this to work or if my i3 6100 and this mob would work ?

any progress? same error

i am stucked here.. does any have a solution?

@salamero, please update your profile (personal details) with your build (Motherboard, CPU and Graphics Card).

The Rules said:

Profiles need to contain at least your primary system to assist others with helping you.

Click to expand...

Try disabling the Serial port (SuperIO) in your BIOS settings.

Need help with gigabyte ga h110m s2h i5 6400 processor msi gt 710 graphics card unable to install elcapitan would love someone to help me getting system uptime in nanoseconds