Contribute
Register

Can't boot with 2 GTX970

Status
Not open for further replies.
mederock

mederock

Joined
Dec 28, 2014
Messages
38
Motherboard
GA-x99-UD4
CPU
i7 5820k
Graphics
RX580
Mobile Phone
  1. iOS
Hi,

This is my 2nd mHackintosh with clover and I have a problem that i can't solve.

Her i my config :
gigabyte ga-X99-UD4
i7 5930k
32 gb ram
2 gtx 970 evga

I installed yosemite with no problem with just one gpu. After I installed the 2nd gpu, i can't boot, I have this message :
OsxAptioFixDrv: Allocaterelocblock : can not allocate relocation block (0X166189 pages below 0X100000000) : not found


I tried with osxaptio2drv, boot flag slice=0, I rebuilded the kernel, and I still have this problem.
I don't understand what is the problem, with just one gpu yosemite works perfectly.

The problem was already there before i install nvidia's drivers.
my boot args are :
npci=0x2000 nvda_drv=1 kext-dev-mode=1


Any ideas ?
 
Hack Pro X99 High Sierra
GA-X99-UD4 |  i7 5820K |  RX 580 Pulse 8GB
mederock said:
Hi,

This is my 2nd mHackintosh with clover and I have a problem that i can't solve.

Her i my config :
gigabyte ga-X99-UD4
i7 5930k
32 gb ram
2 gtx 970 evga

I installed yosemite with no problem with just one gpu. After I installed the 2nd gpu, i can't boot, I have this message :
OsxAptioFixDrv: Allocaterelocblock : can not allocate relocation block (0X166189 pages below 0X100000000) : not found


I tried with osxaptio2drv, boot flag slice=0, I rebuilded the kernel, and I still have this problem.
I don't understand what is the problem, with just one gpu yosemite works perfectly.

The problem was already there before i install nvidia's drivers.
my boot args are :
npci=0x2000 nvda_drv=1 kext-dev-mode=1


Any ideas ?
Click to expand...
try with slice=8, then 16, then 32, 64, 128, etc.

I had to use slice=128 for the GTX980 on the Asrock X99M Killer
 
That sucks. AptioFix2drv worked for me, but I'm only using one 970, and I'm using a different board.
 
I had the same thing. I had it working fine with 2. Then it stopped on a reboot. Loaded aptio2 then after a few more reboots it stopped. Now I can't get it to work at all with 1 card and the Thunderbolt card installed. Very similar errors, they change depending on 1 card or 2 aptio 1 or 2 TB or not but all boil down to resource allocation.

Mark
 
I have the exact same problem, but with GTX980's
 
Same issue - I have one GPU and if I add the thunderbolt card, clover gets stuck with the same error.
 
After I update bios same error.Only Clover worked now with out efi (mbr)partition.
 
Status
Not open for further replies.
Copyright © 2010 - 2024 tonymacx86 LLC
Back
Top